Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 8/2003 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Location/Replacement of the Ignition Reference Sensor 700 1989

posted by  Val on  Thu Jan 24 10:51 CST 2002
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

Herb,
Now I'm really confused...I did take a look at the picture of the Ignition Reference Sensor for my 740GL, 8-valve ( that makes it 4 cyl.) and it looked like something described in FAQ, i.e. needing a housing and secured with a 10 gauge bolt right by side. It has a long and thick wire with a connector at the end. As I understand, the Hall sensor serves as RPM sensor only on the turbo models, not normally aspirated. So mine should have the one that goes into the bell housing. Am I right?





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Location/Replacement of the Ignition Reference Sensor [700][1989]
posted by  Val  on Thu Jan 24 07:27 CST 2002 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.