Volvo RWD 140-160 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 9/2002 140-160 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Supercharging a B20 (AGAIN) 140-160

posted by  ereuter on  Sat Jul 26 13:39 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat Oct 20 15:29 CST 2007
[RELATED]


-Are there any electronic injectors to suit a B20E head?

The stock injectors on a B20E (D-jet) are electronic. They are low impedence though (2.5 Ohm), so you may need ballast resistors if the Wolf 3D doesn't have peak-hold drivers.

BUT, as Phil said, the high compression E head probably isn't the best choice for forced induction.

If you don't want to deal with fabricating injector mounts on the carbed head, you might consider using an early B20F head (D-jet/6-bolt), and using the stock injectors.

I'm using stock injectors with ballast resistors with my Megasquirt EFI controller. See
http://www.southroad.net/ms for info on that.

Eric
--
'66 122 Coupe 110k '97 850 Wagon 130k






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Supercharging a B20 (AGAIN) [140-160]
posted by  Tom 760t  on Sat Jul 26 11:11 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.