Volvo RWD 1800 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 4/2001 1800 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

M41 countershaft spindle 1800

posted by  someone claiming to be amazoniac on  Thu Apr 1 19:32 CST 2004 [RELATED]



I'm piecing together an M41 that I acquired recently and which came in many pieces all in a box. I was just kind of playing with all of the major pieces in order to figure out what I might be missing and such when I discovered a possible problem.

I found that the three control spindle/rods that go through the top of the case fit through just fine, but the spindle/rod which goes through the countershaft-gears at the bottom of the case is slightly larger in diameter than the control rods and would not fit through its bottom holes at the bottom of the case. Must this spindle be strongly forced through its holes, or might I have a spindle/rod from a different transmission, say an M40?

-A





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New M41 countershaft spindle [1800]
posted by  someone claiming to be amazoniac  on Thu Apr 1 19:32 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.