Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 12/2003 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

I hope this is not what I think it is ... 700 1992

posted by  Andrew in AL on  Mon Jun 28 13:19 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 06:17 CST 2014
[RELATED]

I know that #4 is dead (at idle, anyway) Would I learn anything else by the 1 minute run - then touch method?

I went to a local shop today, and the mechanic done a compression check on #2 & #4. He did #4 first, with the motor running. It got just a bit past 50 - with him releasing the pressure and then allowing it to come back up, and his comment was that it was low. Then he did #2 the same way, and it was a bit higher - but not that much. I think this befuddled him a bit.

Next he disconnected the coil, and cranked the motor for about thirty seconds without releasing the pressure on both 2 & 4. There might have been a 10% difference - both reading about 100 with this method.

Anyway, tomorrow AM - I am going back up there - and we are going to swap the 2 & 4 injectors - to see if it repeats the problem on #2. If it does then we will know it is the injector.

Thanks - Don
--
'94 940T (160K) , '92 745T (200K+)






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New I hope this is not what I think it is ... [700][1992]
posted by  Andrew in AL subscriber  on Mon Jun 28 07:48 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.