Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 1/2004 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

pulling engine and tranny at same time.... 200 1987

posted by  Five Bricks on  Mon Aug 9 08:55 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue May 22 15:09 CST 2007
[RELATED]

Having gottne a trany out of a '91 244 by removing both, and out of a '92 244 by dropping just the tranny, I have to agree with twoforty, dropping the tranny is a LOT easier. I put the car on ramps, used a $35 Harbor Freight tranny jack, and went at it. Based upon B-Board tips, I used a 2' extension, a good thin-walled 18mm socket, and a u-joint to get to the bolts at the top of the bell housing. I also made sure the torque converter didn't fall out. My biggest problem was braking the tranny oil lines loose, but eventually PB Blaster did the trick.

Good luck.
--
'88 244GL, '89 244GL, '90 244DL, '91 244, '92 244






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New pulling engine and tranny at same time.... [200][1987]
posted by  Dan D.  on Sun Aug 8 21:36 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.