Volvo RWD 444-544 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 12/2003 444-544 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Removing Ignition Switch 444-544

posted by  Ron Kwas on  Sun Apr 17 04:21 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 04:03 CST 2014
[RELATED]

Sil;

If it's the same as 122 (likely!)...two phillips screws hold the IGn switch to the dash, and (three?) hexhead bolts hold the coil to the firewall...so it will be usefull to be prepared with nut drivers/sockets in the 3/8" to 7/16" range (possiblly metric also...it is a Bosch part as you know). The nuts securing the wires, use 7mm or 9/32" nuts. The lock cylinder needs to be removed first, so you will need the key or you'll have to pick the lock into the IGN ON pos so that you can puch the release pin.

Cheers





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Removing Ignition Switch [444-544]
posted by  Sil subscriber  on Sun Apr 17 03:49 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.