Volvo RWD 1800 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 11/2012 1800 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

pulley problems 1800

posted by  davidws on  Fri Jun 24 08:15 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

i am trying to upgrade my old generator to a new one wire alternator. everything seems to be going good except one problem. i am trying to use the old bracket--ive removed the rubber place holders and slid the bracket as far forward as possible and made a new tension bar but, the pulley still sits back about 1/2 to 1/4 of an inch. and im not sure if this is going to put strain on the system. it seems like quite a job to get in there and actually modify the bracket and i dont think i have the tools. so what is the opinion on this? is the alignment of the pulley necessary?






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New pulley problems [1800]
posted by  davidws  on Fri Jun 24 08:15 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.