Volvo RWD S90-V90 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 12/2009 S90-V90 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Cannot remove balljoints from control arm....damn it! S90-V90

posted by  volvito on  Fri Aug 5 05:11 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Mar 23 04:59 CST 2014
[RELATED]

Well, take off the ball joint bolts and bushing bolts and remove the whole control arm out. Then you can realy whack the ball joint with whatever way you want or even press it out. When you put the bushing bolts ba on lower the car to raise the control arm before you tighten the rear bushing bolts. This is very inportant step to set the bushing right. Hey, you may want to put new rear bushing by the way. They brake easy over time and make your steering wiggle.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Cannot remove balljoints from control arm....damn it! [S90-V90]
posted by  sidmon  on Thu Aug 4 02:21 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.