Volvo AWD V70-XC70 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 10/2006 V70-XC70 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Solder is fine if you know how to do it. V70-XC70 1998

posted by  Thor's Hammer on  Fri Feb 22 03:30 CST 2002
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

Why stay away from solder? If you know how to do it its super easy, and with todays surface mount chips its even easier and safer, (no holes or traces to burn up) Both flash and solder are good and if you have a socket then you can switch between programs, or if you have a socket you can put in a special board with a switch so you can switch programs on the fly, thats what I have.


Rich S.

97 BSR S3 850R MIM Velencia 17"s, Ohlins Strut tie bar, cold air kit, program switch, 262 FRHP 302 FWTorque. 15K hard miles at 1.3 bar.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Should I bother with the ECU???
posted by  KOJACK  on Wed Feb 20 02:47 CST 2002 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.