Volvo RWD Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 6/2004

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Question on the counterhold tool

posted by  Andrew in AL on  Fri Jun 13 16:14 CST 2008
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 06:17 CST 2014
[RELATED]

Just replaced a harmonic balancer on my nieces 740. Bought the hold tool for this and for future work.

It attaches to the tensioner bolt at the top, and the three prongs latch into the pulley slots, of course.

PROBLEM I had was getting it to go over the bolt, and into the pulley at the same time. It was like the top hole on the tool was drilled too low. Finally I got it just a bit on the bolt, and wedged a bit into the pulley. Then I tapped in place with a hammer.

It messed up the top side of the bolt on the tensioner, but the nut fixed all that, remaking the threads when put back on.

I think it should not have been that hard to get on, so I have to have been missing something.

What was it? ...unless the tool was made a bit wrong.
--
' Of all bad men religious bad men are the worst. '' (C S Lewis






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Question on the counterhold tool
posted by  Andrew in AL subscriber  on Fri Jun 13 16:14 CST 2008 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.