Volvo RWD 140-160 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 4/2010 140-160 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Getting to hate this engine B20B 140-160 1970

uid 5322's pic
posted by  alschnertz on  Sun Sep 25 01:28 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 10:32 CST 2014
[RELATED]

The in-line filter was changed @ 120,000 and doesn't look plugged. Didn't think to change it since I normally get 15,000 out of them with no problems. I will change it and see if it makes the difference.

I did find an intake leak which is why I had the manifold re-surfaced. Thought I was on to something with that...guess not.

I've tried adjusting the carbs by getting the highest idle, then highest idle plus 1/3 turn richer to no avail. Something is screwy though. My '72 has the same carb setup and the jets are about 0.060" below the carb bridge. On this one the jets are down around 0.250"! Granted it idles smooth, but that seems really low.

The timing is set to the factory spec. I've tried other settings, vacuum connected / disconnected but nothing has been as smooth as the factory setting.
Minor pinking when hot and pulling a heavy load up a grade.

Does this help any?
Thanks
--
'60 544, '68 220S, '70 145S, '72 144E, '86 745T






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Getting to hate this engine B20B [140-160][1970]
posted by  alschnertz subscriber  on Sat Sep 24 12:36 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.