Volvo RWD 140-160 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 8/2003 140-160 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

thanks for the feedback 140-160

uid 5098's pic
posted by  Sil on  Mon Oct 10 03:24 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 07:24 CST 2014
[RELATED]

Re needles. You are loosening the screw that goes in from the side of the piston, right? Not the setscrew that you see in the bottom. If the needle won't come out, let it sit overnight with some PB-Blaster on it. Next day try to wiggle it a bit, then push it down, and then try to pull it out - carefully so you don't bend the needle.No pliers, unless you wrap the jaws in something to keep them from scarring the needles. If they won't come out, keep repeating the exercise. They should, eventually give.
Good luck,
Bob S.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New SUs general [140-160]
posted by  someone claiming to be hudson  on Sat Oct 8 08:29 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.