Volvo RWD 140-160 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 1/2002 140-160 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

SUs general 140-160

posted by  someone claiming to be TimC on  Sat Oct 8 20:52 CST 2005 [RELATED]

Depending on what you are using the car for either the HIF6 or HS6 are good.
Maybe if you are doing some racing the HIF6 is possibly best as the float bowl is on the bottom which supposedly leads to less fuel surge cf the HS6.
I have just replaced some Strombergs for HS6's using a 122S alloy inlet manifold, heat shield but no spacers and this is here in Australia where temperatures can get very high in summer. I have put on ram stacks and filter socks.
This same setup caused no problems on the 122S I had.
The needles on the HS6 should be KN or KD which are the usual ones specified.
Good luck,
TimC






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New SUs general [140-160]
posted by  someone claiming to be hudson  on Sat Oct 8 08:29 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.