Volvo RWD 120-130 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 12/2003 120-130 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Windshield seal install 120-130

posted by  chakra on  Fri Nov 18 12:49 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat Feb 7 10:17 CST 2009
[RELATED]

I have done 3 or 4 windshields--not a huge number--but never had a very tight fit against the glass. It was snug, but pretty easy to get on. I would take another look just to be sure everything is lined up OK before moving forward.

As others have said, don't worry about the bedding compound setting up. Be sure you put tape on the dash and on the car. It will make clean up much easier. After it is installed you might want to use your caulk gun to run an additional bead of compound underneath the rubber, particularly along the top. This will help you be sure water can't run down inside.

Good luck!
--
Tim--'72 ES, '90 240






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Windshield seal install [120-130]
posted by  justin  on Thu Nov 17 16:14 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.