Volvo RWD 140-160 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 5/2012 140-160 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

How to install a M41? 140-160

posted by  Charlie142 on  Sun Feb 11 07:08 CST 2007
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat Jul 23 15:38 CST 2011
[RELATED]

Most ITB cars use the smaller drive shaft because of clearance issues with the tunnel. every little bit helps. I have broken a small drive shaft and would prefer to use the stronger big one if I could, but my car is pretty low to the ground and softly sprung so I expect I'll have problems. It's OK under the rules we run.

I friend just told me that I may need to change the output flange on the OD unit to run the smaller drive shaft.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New How to install a M41? [140-160]
posted by  Charlie142  on Sun Feb 11 04:07 CST 2007 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.