Volvo RWD 140-160 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 11/2002 140-160 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

How to install a M41? 140-160

posted by  Redwood Chair on  Sun Feb 11 07:24 CST 2007
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue Feb 25 21:29 CST 2014
[RELATED]

AT short shaft is medium length,No go,
unless shortened at a driveline shop.
It may be possible to weld the larger yoke to your existing
small shaft,during the shortening process.
Getting the length right is the hard part.
Special tail support crossmember in rear set of holes.
You wll be able to adapt existing one with some cutting,
and welding.
Post back if you need some measurements.
I was thinking of mounting the OD switch on the
steering wheel paddle style,like the latest race cars.
Ken
--
69-145-S ; 71-145-S ; 72-145-E ; 72-1800-ES ; 87-245-DL






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New How to install a M41? [140-160]
posted by  Charlie142  on Sun Feb 11 04:07 CST 2007 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.