Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 4/2014 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Replacing Engine Harness any thing to watch for? 200 1985

posted by  don hodgdon on  Mon Nov 19 02:53 CST 2007
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat Mar 2 07:50 CST 2013
[RELATED]

The hardest time I had when swapping out harnesses was running the alternator wires. Volvo runs them under the front of the engine, below the crank pully. Not only is it very dirty under there, it is a common spot for the wiring to fail. What some will do is extend the wires and run them along the passanger side fender to the alternator.

While the harness is out, it is a good time to clean out the oil seperation box and flame trap assembly.

Good luck!


--
Don - '89 744ti, '85 Alfa GTV6






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Replacing Engine Harness any thing to watch for? [200][1985]
posted by  Stickbuilder subscriber  on Sun Nov 18 15:22 CST 2007 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.