Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 10/2007 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Bench testing the starter 200

posted by  gopeshs on  Tue May 27 06:24 CST 2008
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon May 19 14:01 CST 2014
[RELATED]

Thanks
I have taken it off the car. Those nuts are nuts. The terminal and wire connections everywhere are clean, I cleaned them a week ago. The problem started when I tried to loosen the crank shaft center bolt by using starter . It got stuck and have not budged since even after banging it with steel pipe, Small hammer etc. I suspect that solonoid might be shot but if one can not get a new solonoid then whole starter is gone.I will test the thing today.



--
DD-1990 240 DL SW M47II FI 3.1 220 K miles Turbo Sways,Custom headlight circuit ,Insulated roof,Tinted Glass,






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Bench testing the starter [200]
posted by  gopeshs  on Tue May 27 04:04 CST 2008 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.