Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 4/2010 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Codes pulled from new car 200 1993

Well....I am wits end. The check engine light is on again and the codes are 113 and 232. Same as before.

The following has been done so far:
TPS replaced
AMM replaced
FPR replaced
IAC replace (rpms up upon start then back down nicely. Idles perfectly)
Black box under intake removed and cleaned
Vacumn hoses replace
Air filter replaced
New plugs at .28 Old plugs blackened and sooty on the ends
New Dist and rotor Old cap and rotor shot
Flame trap cleaned
New 13913 O2 sensor replaced (two white one black spiced/crimped to original two white one black wires. (does it make a difference which white is to which white?) Old O2 sensor was black and sooty
Chinese water torture and seafoam engine. Runs terrific. Think the neighbors were about to call the fire dept with all of the smoke.
Cat is really new

When I clear the codes I get 1-1-1 and the check engine light goes out. Then for some reason after awhile the light comes back on and the codes are again 1-1-3 and 2-3-2.

I dont know what else to do at this point. Any ideas?

Thanks
Frank






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Codes pulled from new car [200][1993]
posted by  fpeck1948 subscriber  on Thu Sep 24 09:25 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.