Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 6/2003 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Codes pulled from new car 200 1993

Sitting here with a thought to run by you...

I spliced the connections together using the blue hollow tube type and the crimped each numberouse time to make sure of the connections.

Did this with both whites and one black.

After all three were done I coated both end of the blue tube with RTV silicone sealant.

Bundled all three together and wrapped generously with electrical tape and the sprayed the entire assembly with undercoating.

Coulf the RTV sealant be conductive and should I have done the above procedure seaparately instead of doing them together in a bundle, maybe causing a conductivity problem.

Just a thought while sitting here pulling my hair out......

Frank






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Codes pulled from new car [200][1993]
posted by  fpeck1948 subscriber  on Thu Sep 24 09:25 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.