Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 6/2009 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

crank position sensor 700 1991

posted by  greg_mustang on  Tue Apr 3 11:32 CST 2012
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat May 10 07:26 CST 2014
[RELATED]

Thanks.

I ran the sensor test via the ECU with pin at connector 6, and got no reading (no code) for the crank sensor (sensor is supposed to be 6 months old)
I replaced the sensor with the old one which likely was intermittent, and again got no reading.
I know for a fact I was testing fine on the wekeend, but it was before I replaced it (i.e. before I touched it).

The conenctor was sprayed, I pulled back the boot on it, it looks A1.

so... 2 of 2.
Well, I am going to buy a new one and cross my fingers.

could this be an ECU failure?
--
Greg Mustang - www.volvoclassic.bravehost.com






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New crank position sensor [700][1991]
posted by  greg_mustang  on Tue Apr 3 06:15 CST 2012 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.