Volvo RWD 120-130 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 2/2013 120-130 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

U-joint proper fitting in the front yoke 120-130

posted by  DBS on  Wed Aug 15 21:57 CST 2012
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 17 19:33 CST 2014
[RELATED]

I don't think any needles were stuck between the top of spindle and cup- all of the four cups look evenly seated over the spindles.

I will try hammering more...but would there be any chance that the ends of the yoke got bent toward each other cause by the vise when I was squeezing the old cups out? I noticed that the distance between the "u" of this first yoke is shorter than the "u" of the other yokes on the shafts. Don't know if that is normal.

If bent yoke is possible, would anyone have extra yoke in good shape for sale? The first yoke that bolts to the tranny would be what I need.

Thanks,

-DS





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New U-joint proper fitting in the front yoke [120-130]
posted by  DBS  on Wed Aug 15 20:16 CST 2012 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.