Volvo RWD 120-130 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 10/2008 120-130 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Replacing a 122... 120-130 1966

posted by  VovOtaku on  Sat Aug 10 16:52 CST 2013
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Aug 11 09:52 CST 2013
[RELATED]

Really sorry to hear about the accident, very good that you are fine. Depending on the damage, quite a bit is "bolt-on" (I have crunched the front end of mine a couple times, bolt-on fender/hood/nose, paint and "voila"). Rear panel work (or unibody structural damage) is a bit tougher, though still possible (friend had a totaled from rear 122, sectioned and welded a "new" end on, full respray, and it gets shown in shows with no-one noticing!)
Personally like the 4-door 122 best (Still own two!) and say it's a bit easier to work on (space/design-wise) than either the 544 or 1800. Swapping over the mechanical bits is a chore, but really not too bad - that's how I got started in Volvos (and serious car tinkering) - by swapping over a "hot" engine and parts into my 4door 122.
Good luck!
--
66 122S 88 745 90 740T 95 940






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Replacing a 122... [120-130][1966]
posted by  Dylan Berichon  on Thu Aug 8 01:58 CST 2013 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.