Volvo RWD Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 7/2010

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

123 Distributor install help - B20F

Well I hope I'm just an idiot and didn't realize what I was doing. I pulled the old dist. out with the rotor pointed at #1 wire and timing mark at 10btdc then put the new one in with the same rotor orientation. Does the rotor point at #1 wire during both the compression and exhaust stroke?
If so, that's likely the issue. Thank you!






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 123 Distributor install help - B20F
posted by  someone claiming to be SprtWgn  on Fri Feb 19 20:32 CST 2016 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.