Volvo RWD Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 6/2004

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

123 Distributor install help - B20F

posted by  someone claiming to be SprtWgn on  Mon Feb 22 12:20 CST 2016 [RELATED]

If I removed the old distributor with the motor at 10btdc and rotor pointing at #1 position, that = firing position for #1, correct? These distributors can't be installed 180 degrees out due to the offset drive, right? So, installing the new dist. should be as simple as dropping the new unit in and static timing the system. Not really any chance to get it upside down, right? So what else might be the reason I get no start with this brand new 123-Distributor?
Thanks again and I hope I'm not being too dense.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 123 Distributor install help - B20F
posted by  someone claiming to be SprtWgn  on Fri Feb 19 20:32 CST 2016 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.