Volvo RWD Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 11/2009

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

123 Distributor install help - B20F

posted by  someone claiming to be SprtWgn on  Mon Feb 22 12:57 CST 2016 [RELATED]

The rotor on the new dist. does point to #1 (approx.) when installed. It's a model made specifically for B18 and B20's so I assumed it would be set up properly for the motor. I believe the drive can be removed and adjusted more slightly that 180 degrees on this unit so maybe that's where the problem lies.
I will put the old unit back in to verify and then make sure the new unit points to EXACTLY the same position. I was second guessing myself about being at the top of the compression stroke... When the rotor on the new dist is pointing towards #1 wire and the engine is at tdc I can slightly wiggle both rockers on #1 through the valve cover cap hole (as suggested by Planetman).






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 123 Distributor install help - B20F
posted by  someone claiming to be SprtWgn  on Fri Feb 19 20:32 CST 2016 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.