Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 11/2004 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Fuel injection problem 200

posted by  Don Foster on  Thu Mar 13 23:28 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Oct 5 11:53 CST 2014
[RELATED]

For Bentley manuals, go right to Bentley Publishers' Website.

You can always check eBay for manuals.

You've described the CIS motor or idle air valve (IAV).

The control pressure regulator is mounted on a bracket, which is bolted low on the block, behind the ignition distributor and tucked in behind the airflow sensor. You can get small hands in to it if you remove the distributor cap and rotor.

The cpr has two fuel lines attached (using banjo bolts), one electrical cable, and a vent hose, which is open to atmosphere.

Be very careful to NOT drop or lose the copper washers used with the banjo fittings.
--
Don Foster (near Cape Cod, MA)






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Fuel injection problem [200]
posted by  someone claiming to be Tim Coen  on Tue Mar 11 06:10 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.