Volvo RWD 140-160 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 12/2010 140-160 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Hi Guys! 140-160 1968

posted by  someone claiming to be shayne on  Tue Jul 1 12:26 CST 2003 [RELATED]

Uh, sorry. I haven't been here in a while.

Kyle,
Have Rhys rebuild the carbs for you. You don't want Shayne re-building them. Have you seen his "shop"?
Seriously, if there is any throttle shaft slop, you want a pro shop to do the machining. I can install/center new jet tubes, install new needles, clean-up the bodies, match the "drop", install on the motor and balance but if the throttle shafts are sloppy, it'll run perfect 'til the first time you step on the gas. I am not set up to drill SU's out and rebush 'em.

Phil,
Thanks for the tips on the motor I'm not working very hard at building!

Rhys,
Hey Buddy, Hows it goin'? Good to see you back on the board!

vvpete,
You sound like an old school Volvo nut! Nice to meetcha!

shayne.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Shayne... [140-160][1968]
posted by  KLR142  on Fri Jun 27 14:18 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.