Volvo RWD 140-160 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 4/2004 140-160 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

How to pull distributor gear? 140-160 1974

posted by  mjamgb on  Fri May 13 04:56 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue Sep 4 14:53 CST 2012
[RELATED]

I believe the IPD HD pump only has the relief spring modified and the reinforcing ring included for the drive end.
Hard as that supply tube was to press into the block gallery I can't believe it ever leaks! Of course, I can certainly understand pinching it during installation.

If the ring is in place on the pump shaft there is little likelyhood of the socket spreading and interfereing with the bush or the ring would have been left in there!

The engine is "in" and more or less running, eh? If it were out I would suggest a little valve grinding compound and some hand-lapping (remove gear and shaft from pump to accomplish).

It is still possible that some varnish is on the bush... perhaps innovation with a scotchbrite pad will help? lightly scour the bush in place? Still have the potential for nasties in the sump/oil galleries, however.

Maybe a little gumout carb cleaner and a cotton swab.

--
Mike!






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New How to pull distributor gear? [140-160][1974]
posted by  uniberp  on Thu May 12 02:45 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.