Volvo AWD V70-XC70 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 2/2010 V70-XC70 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

head off. V70-XC70 2006

Good afternoon, Klaus,

Good couple of days. Once I managed to get the remaining four studs out of the exhaust manifold side of the engine, the head became loose on the aft side.

Thus, it was loose on both front and rear sides. but not on the RH side. Turned out there was one bolt holding the front plastic cover to the head. Once removed, we were able to lift the head off the block with comparative ease.

The head gasket is discoloured black between number two and number three cylinders.

Some lesser discolouration between number one and number two.

This is on the upper [head] side of the gasket. Lower side looks clean.

I will try to upload some pictures.

Bob







THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New head gasket replacement instructions [V70-XC70][2006]
posted by  muskox37  on Wed Dec 8 17:28 CST 2021 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.