Volvo RWD 140-160 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 8/2006 140-160 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

How to install a M41? 140-160

posted by  Charlie142 on  Sun Feb 11 04:07 CST 2007
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat Jul 23 15:38 CST 2011
[RELATED]

I just bought a M41 transmission to try in my ITB race car. I have heard of them being used to advantage along with a 4:88 rear. Judging from the remote shifter it came from a post ‘71 142.

Two questions. What drive shaft do I use? I have been using the smaller diameter shafts for a little more clearance in the tunnel and less weight. Is there a small diameter front drive shaft section that will adapt to the large flange on the OD? Do I need to use a large diameter drive shaft? I have a large diameter short front half drive shaft from an automatic transmission car (I think) that bolts up to the flange on the OD. Is it the correct length for an OD trans?

Second how is the rear of the M41 supported? Do I support it with the same mount as a M40 or is there a mount that goes behind the OD extension?

Thanks,

Charlie






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New How to install a M41? [140-160]
posted by  Charlie142  on Sun Feb 11 04:07 CST 2007 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.