Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 6/2015 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Help! 200 1989

posted by  yama on  Sat Dec 8 01:47 CST 2007
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 25 05:26 CST 2013
[RELATED]

It sounds like your cam sprocket might not have been properly torqued after the timing belt change causing the alignment dowel to eventually shear. Like Sven suggest verify that the crankshaft pulley is spinning while the starter is engaged. If its spinning and the cams aren't then most likely a sheared pin and loosened cam sprocket. Its also possible that the belt broke.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Help! [200][1989]
posted by  asg1986  on Fri Dec 7 14:12 CST 2007 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.