Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 10/2005 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Another Opinion on 1-1-3 Code 200

Hi Dan,

With all due deference to Art, I'd like to offer the Regina FI's version of the 1-1-3 code. Netted out, it's based on injector ground side current measurement by the ECU. Based on the similarity between the LH 2.4 and Regina ECU's (from an external I/O and pin-out comparison), I think it's quite possible that the LH derives the 1-1-3 the same way.

Basically the Regina Green Book says that too much or too little current drawn (no specifics given), will set the 1-1-3, suggesting possible causes like an open on either the injector voltage or ground side, or a short to ground between ECU 18 (same for LH) and the injectors.

Believing the "final" (external) ECU ground point is one of the two on the Fuel Rail support brackets, I'd try removing and cleaning both of them. Can't hurt.
--
Bruce Young, '93 940-NA (current), 240s (one V8), 140s, 122s, since '63.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 1 91 240 - Won't idle, CEL 1-1-3, then fast idle [200]
posted by  UFgator  on Tue Jan 20 02:44 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.