Volvo RWD 120-130 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 5/2007 120-130 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

More Information... 120-130

I tried using the solvent/oil method (WD40) method and was unable to find my vacuum leak; I only found the leaks by noticing dark stains around the PCV nipple and manifold plug on my otherwise clean and shiny intake manifold.

In the end, I aggressively resealed everyplace that might be a leak with permatex, and the problem went away. My fuel economy about doubled, too.

One thing I observed with my wideband AFR gauge, when I still had the leak, was that the needle would peg at the leanest extreme when I would let my foot of the gas. Now that the leaks have been fixed, the needle still shows the mixture going lean if I let my foot off the gas, but it is only going to around 14 or so, instead of 18+. I should probably recalibrate my gauge now that I've fixed the leaks.

Bill






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Why Do HIF's Seem to HATE my Engine? [120-130]
posted by  122_Canadian  on Wed Apr 29 17:51 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.