Volvo RWD 900 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 12/2016 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Quick note in addition to posts 900 1994

posted by  chris herbst on  Fri May 3 14:30 CST 2002
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Oct 20 20:32 CST 2014
[RELATED]

If you have access to an impact wrench, torque the nut first, then mark a reference point.

THEN blast the nut to the right angle with the impact wrench. Use the lowest setting unless it won't move the nut (so that you don't smoke the nut). This is pretty effective in getting that last few degrees that normally out of reach. I've never had to do a Volvo sealed hub on the 700/900 series, but the design is similar to most sealed hubs on non-drive axles.
--
Chris Herbst
1992 945, 71k
Volvo shop tech






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Front wheel bearings on a 940 [900][1994]
posted by  sondrew  on Fri May 3 03:35 CST 2002 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.