Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 5/2003 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Ignition switch question??? 200 1980

Dave,
I checked positive side while cranking, solid voltage, checked the negative side, pulses on and off. Still no spark from the coil, accept as I let go of the key, while cranking. With ignition off have 9000 ohms from tower to each terminal of the coil. across the two screw terminals 2.1 ohms. The resistor underneath shows 1.9 ohms. Also I can read the voltage drop across the resistor, 14.6 on the blue side, 11.5 on the brown side. I am at a complete loss. According to the Chilton's it should be running, its not. Still no center wire spark during cranking, only one short burst as its let go, and not everytime. I also checked the ohms of the coil wire and tried more than one.
Its not the ignition switch either, you were right, tried a known good one, same condition.
Please help if you can...
Thanks...
Chuck Jaxel
--
Chuck Jaxel, Pine Hill NJ, Near Philly...






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Ignition switch question??? [200][1980]
posted by  Chuck Jaxel subscriber  on Wed Apr 23 10:41 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.