Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 12/2008 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

tool for OD 700

For the OD unit control plugs. I use a "Martin" (Brand Name) Adjustable spanner wrench #482. I purchased it from a bearing supply company.

Martin has a web site which lists vendors in various areas of the country.

http://www.martinsprocket.com

DO NOT use Dextron. It will allow bad things to happen inside your TRANSMISSION....the OD could care less. Your fluid choice is limited to Type F ATF, a straight 30w Motor oil if temp never gets below 20 degrees F. or a synthetic trans fluid that is Type F specific. Other Synthetic tans fluids can cause problems with the OD by being too slippery.

Under the center plug is the pump. Anything in there would cause a problem warm or cold so at this juncture, leave that area alone.

Did you change the internal O-rings in the solenoid?

Slipping when warm can also be caused by low fluid.

Duane






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New tool for OD [700]
posted by  turbo+  on Thu Feb 19 07:46 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.