Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 4/2009 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

AC microswitch 200

When properly charged mine have always shown some bubbles in the sight glass as pressure builds up then just a few bubbles when up to pressure.

It's a real pain to try to tell the difference between an empty/very low system and one that is up to pressure. I swore the one in my '84 was fine but decided to add some R-12 anyway, about 1lb into it I started to see bubbles, turns out it was just barely full enough to trip the pressure switch but not full enough to make any bubbles.

Your best bet would be to start the car, switch the AC on and go out and look. If you see bubbles while it builds up pressure then nothing, you're probably OK. Somehow I don't think you will find this to be the case, it would be cool at least if it was.

It "should" be labeled if converted, as you know R-12 is very expensive. I have had a few friends that have used compatable refrigerants to replace missing R-12. Keep in mind that if you do this it really pisses off a shop that may get it's equipment contaminated by mixed systems. Not an issue if you plan to keep doing it yourself.
Good luck
--
Dave Shannon
Spring Valley, California
'67 1800s
'73 1800ES
'88-240
my pages






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New AC microswitch [200]
posted by  bulletproof subscriber  on Thu Jun 2 03:35 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.