Ok so here is latest p1800 philes
So I don't have gas at the csv. When I ground single wire from thermo timer
I get spraying at the csv with 10.5 volts on the meter. The battery voltage
is fully charged and drops to 11.5 at the battery terminals when cranking.
I guess this value depends on cranks amps of battery.
With regards to pressure sensor test I get 95, 367 and Infiniti on
resistance tests. When I do suck test I got nothing as pipe appeared to
have a leak. I replaced with a new piece of half inch fuel rated tubing
upon performing again I can hear diaphagm operating with enough vacuum to
'grab' my lips.
So then I crank and crank and crank...! And not even attempting to fire
now...I was hoping I would get an attempt to start now
Any ideas folks?
Thanks in advance
|