Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 4/2006 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

engine removal 200 1990

No. But I had encouraging words from an acquaintance who has dealt with this sort of problem many times -- but it does require being there and working through a manager. As of January NY has allowed the undocumented to obtain a drivers license. Since then the DMV offices have been mobbed. Then the virus business began. Meanwhile I'm working out the detail stuff. I was very proud of the way the heating/cooling system plumbing went. I used Volvo heater hoses throughout -- Volvo steel pipes too and even had enough Volvo clamps for all the heater and radiator hoses. I was concerned that one lifter wasn't working as there seemed to a slight miss but because I didn't have the cooling system set up I only could run it a few minutes at a time. Cooling system working now, I discovered the hose w/cap I put on the intake manifold brake vacuum fitting temporarily, had a crack. Missing no more :-) Happy Days -- Thanks for asking -- and BTW -- Have you had any inquiries about your V8?






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New egine removal [200][1990]
posted by  maplebones  on Wed May 20 18:02 CST 2020 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.