Volvo RWD Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 1/2004

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

More tranny bits M41...Attn: Peter

uid 779's pic
posted by  matt b on  Tue Nov 19 09:17 CST 2002
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue Oct 14 16:33 CST 2014
[RELATED]

OK...so, you say that if I have the bronze bush in place of the needle bearings...either the old bush or new needles will work?

I think the lay bearings are probably OK...the gearbox was quiet and shifted well to start. Only reason for the project was the broken reverse gear. Best I figure, I don't even need to pull the layshaft or gears out. Just the main shaft and reverse gears... But, I just figured I'd replace all I could while I was in there... This tranny will be bolted to the back of that mystery hot-rod B20, you see....

-Matt






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New More tranny bits M41...bearings [140-160][1971]
posted by  matt b  on Mon Nov 18 10:47 CST 2002 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.