Volvo RWD 120-130 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 6/2003 120-130 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Rear axle differences 120-130

I'll try to remember to take photos. But isn't that retainer on the inboard bearing, not the outboard one? Even so, there was no such ring on the half shaft when I pulled it out. There is something behind the outer bearing but I haven't been able to tell what it is. I'll be taking the parts, when they arrive, to a machine shop to have the bearings pressed on. I'll have to red through Haynes again to be sure I am not missing something.

One thing I already know I am mising; is there a special way to pull the bearing cones into the axle tube after the shaft is in place? Do the backing plates and associated pieces actually pull it home? How can I check the allignment of said cone once installed? I don't want to go through this again.
--
Justin 66 122E, 71 145S
Read vclassics tech!






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Rear axle differences [120-130]
posted by  justin  on Sun Jul 11 08:12 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.