Volvo AWD S60 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 11/2019 S60 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Where are crank pulley timing marks? S60 2007

Thanks for all the responses, guys. I really do appreciate your time, effort, and expertise.
I'm toast, I fear. I finally located the crank marks, approx 90 degrees ccw of where they SHOULD be (SO hard to see!!! I was afraid to turn the crank, so I had to get underneath with a mirror ... very difficult)
In summary, I attempted to use belt tension to react the crank pulley nut torque, and something snapped. But what I did next was the REALLY foolish part, and that was to cycle the engine a few times, before knowing if the crank position had changed. Even if the valve stars aligned and there was no damage in 90 degrees BEFORE I did the cycling, I made sure of it by turning the crank 720 degrees (Thinking I instantly qualify for one of those Darwin awards?) Interesting, I would have guessed there would be additional resistance when contacting more valves, but I did not "feel" anything unusual; the mass of the crank, rods, and pistons mask this, apparently. Any recommended video(s) for the valve and head work? I'll watch, then decide whether to fork over the $3,000. THANKS AGAIN.
--
2007 S60T5 6-SPEED






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 30mm nut on crank pulley / How to loosen? [S60][2007]
posted by  Bill1959 subscriber  on Sat Oct 10 21:48 CST 2015 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.