Volvo AWD S60 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 6/2002 S60 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Where are crank pulley timing marks? S60 2007

If you have spark and gasoline, it should fire. Reminds me of 'lawn mower' syndrome. Or in the old days with a distributer 180 degrees off.

For LMS, you could try pouring 2 tablespoons of engine oil into each cylinder, waiting 30 minutes after the last plug is back in and then starting it. Or, cranking the starter for 30-60 seconds, the oil light needs to turn off, with the gas pedal fully depressed (turns off injectors) until the engine stumbles like it is firing on one or two cylinders, and then let off on the gas pedal and hope the other cylinders catch.

Because you are concerned that a valve might be bent, or two intake valves on one cyl, the engine should still start but run rough on 4 cylinders.

Also a concern is the CVVT, but that should only have an impact when rpms exceed 2000, not at idle. And, no, I don't have literature on the CVVT.
--
Keeping it running is better than buying new






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 30mm nut on crank pulley / How to loosen? [S60][2007]
posted by  Bill1959 subscriber  on Sat Oct 10 21:48 CST 2015 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.