Volvo AWD S60 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 5/2004 S60 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Screwed? S60 2007

I guess what puzzles me the most is the tensioner getting bent. That makes no sense to me as it can travel in both directions.

If I were you, I would put the new belt and tensioner on, with things aligned properly, rotate the engine by hand (without spark plugs) verifying that valves are not touching. Then doing a compression test (unplug injectors). Even cold readings should be over 100 psi.

BTW, anyone reading all of these posts: Never use a breaker bar trying to loosen the crank pulley nut. 300lbs of steady pressure will have negative results on any holding device you can think of.
--
Keeping it running is better than buying new






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 30mm nut on crank pulley / How to loosen? [S60][2007]
posted by  Bill1959 subscriber  on Sat Oct 10 21:48 CST 2015 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.